AGA Elbow, 98deg

AGA Elbow, 98deg




  • 9/16"-18 Male Inlet
  • AGA Female Insert Outlet


Length: 1-1/2" x Width: 3/4" x Height: 1"


Solid Brass Construction
Made with 02 compatible materials

Add To Cart

Country of Origin:  

United States of America

General Installation Procedures:

  • Thread the hose to the 9/16"-18 male thread of the fitting using hand tight pressure. 
  • Once the hose nut is secured using hand tight pressure, use 5/8" Hex wrench and an appropriate wrench on hose nut. 
  • Apply hand tight pressure to both wrenches ensuring a snug fit
  • Thread the AGA Female of the Elbow to the AGA regulator using hand tight pressure.

General Maintenance:

Rinse all products off with clean water at the end of the diving day.  Allow the product to drip dry or towel off.  Do not allow the adapter to sit in dirty water for a prolonged period.  Doing so may discolor the plating.  Discoloration will not have a negative effect on the product other than appearance.

O-ring Service:

O-Rings should be replaced every 200 dives or 1 years, whichever comes first.  Please refer to the proper o-ring replacement guide or Standard Operating Procedure (SOP).  Use only o-rings approved by OmniSwivel International.  

** Always positive pressure test fittings prior to entering the water to ensure that an air tight seal has been made. **