Manual Injection Valve

Manual Injection Valve




  • 1ea 9/16"-18(adapter) Male Inlet
  • 1ea 3/8”-24 Female (optional additional inlet)
  • 1ea 9/16"-18(adapter) Male Outlet



 L= 3.25" x W= .75" x H= 1.75(with adapter) H= 1.15 w/o adapter)



  • Solid brass construction for maximum durability.
  • Oxygen Compatible Materials and O-Rings.
  • Inlet and Outlet adapters can be removed to expose 3/8"-24 female ports.  Allowing for flexibility of hose attachments.
  • Additional inlet on opposite side of push button allows for additional gas inlet if desired.
Add To Cart

Country of Origin:

United States of America

General Installation Procedures:

·         Attach primary air source to the 9/16"18 male fittings marked “Inlet Only”.  Use 5/8" Wrench to secure the connection.  Attach outlet hose to the other 9/16"-18 male fitting.  Secure the connection using same wrench.

General Maintenance:

Rinse all products off with clean water at the end of the diving day.  Allow the product to drip dry or towel off.  Do not allow the adapter to sit in dirty water for a prolonged period.  Doing so may discolor the plating.  Discoloration will not have a negative effect on the product other than appearance.

O-ring Service:

O-Rings should be replaced every 200 dives or 1 years, whichever comes first.  Please refer to the proper o-ring replacement guide or Standard Operating Procedure (SOP).  Use only o-rings approved by OmniSwivel International.