OmniSwivel, Standard Regulator

OmniSwivel, Standard Regulator




  • OmniSwivel for 2nd Stage Regulator
  • 3 way 360deg rotation
  • 9/16"-18 Male to 9/16"-18 Female Insert


  • Solid brass construction for maximum durability.
  • Oxygen Compatible Materials and O-Rings.
  • Viton 75 Orings with Tribolube 71 lubricant
Add To Cart

Country of Origin:
United States of America

General Maintenance:
Rinse all products off with clean water at the end of the diving day.  Allow the product to drip dry or towel off.  Do not allow the adapter to sit in dirty water for a prolonged period.  Doing so may discolor the plating.  Discoloration will not have a negative effect on the product other than appearance.

O-ring Service:
O-Rings should be replaced every 200 dives or 1 years, whichever comes first.  Please refer to the proper o-ring replacement guide or Standard Operating Procedure (SOP).  Use only o-rings approved by OmniSwivel International.   

** Always positive pressure test fittings prior to entering the water to ensure that an air tight seal has been made. **

General Installation Procedures: 

  • Thread the hose to the 9/16"-18 male thread of the fitting using hand tight pressure. 
  • Once the hose nut is secured using hand tight pressure, use 5/8" Hex wrench and an appropriate wrench on hose nut. 
  • Apply hand tight pressure to both wrenches ensuring a snug fit
  • Thread the 9/16"-18 Female of the OmniSwivel to a standard 9/16"-18 Male fitting using hand tight pressure.
  • Use a 5/8" Hex wrench to secure the fitting to the male threads. 
  • Apply hand tight pressure to the connect fittings ensuring a snug fit.