Shut-off Valve: Reversible Sleeve

Shut-off Valve: Reversible Sleeve




Shut-off / Isolation Valve: Turn ON or OFF flow

  • 3/8"-24 Male to 3/8"-24 Female
  • Streamlined for narrow or tight configurations.
  • Reversible sleeve allows flow to be redirected for particular use.
  • Arrow indicates flow ON direction


  • Delrin Sleeve
  • Solid Brass Construction
  • Made with 02 compatible material


Add To Cart

Country of Origin:
United States of America

General Maintenance:
Rinse all products off with clean water at the end of the diving day.  Allow the product to drip dry or towel off.  Do not allow the adapter to sit in dirty water for a prolonged period.  Doing so may discolor the plating.  Discoloration will not have a negative effect on the product other than appearance.

O-ring Service:
O-Rings should be replaced every 200 dives or 1 years, whichever comes first.  Please refer to the proper o-ring replacement guide or Standard Operating Procedure (SOP).  Use only o-rings approved by OmniSwivel International.   

** Always positive pressure test fittings prior to entering the water to ensure that an air tight seal has been made. **

General Installation Procedures: 

  • Thread the Male of the shut-off valve to a 3/8"-24 Female fitting using hand tight pressure.
  • Use a 3/16" Hex Allen wrench through the 3/8"-24 female side to secure the fitting to 3/8"-24 female fitting or 1st stage regulator low pressure port. 
  • Apply hand tight pressure to the connect fittings ensuring a snug fit.